Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateStyles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
See the difference
Before
After
Before
After
Before
AfterHow Much Does Gate Repair Cost in Alexandria?
Gate repair in Alexandria typically runs $175 to $650 for most common fixes, with a failed electric gate opener repair usually landing between $275 and $700 and simple mechanical adjustments starting closer to $150. A full opener replacement on a driveway gate generally falls in the $650 to $1,600 range, and new gate installation is quoted separately once we see the site and the power situation. Every number we give is an estimate; the written estimate after we look at your gate sets the final price.
We’re Alexandria Gate Repair, a gate specialist rather than a garage door company that takes gates on the side. Whether your gate won’t open, won’t close, drags on the ground, or was never installed right, we diagnose the actual problem and tell you what it costs before any work starts. Our technicians have up to 12 years of experience, and we work on the brand you already have.
Key Takeaways
- Most Alexandria gate repairs cost $175 to $650, depending on whether the problem is mechanical or in the automation.
- Electric gate opener repair usually runs $275 to $700; a full opener replacement runs $650 to $1,600.
- We service nine major gate automation brands under one roof: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule.
- Estimates are free, and the price is set per job by the written estimate, not by a flat rate.
- We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Gate Repair Cost Breakdown (2026)
The table below shows typical Alexandria ranges by job type. Use it to sanity-check any quote you receive, including ours. A swing gate with a failing limit switch is a very different job from a slide gate with a crushed roller carriage, and the parts and labor reflect that.
| Repair Type | Typical Alexandria Range |
|---|---|
| Diagnostic and adjustment (hinge, latch, alignment, roller) | $150 – $350 |
| Swing gate hinge or post repair | $175 – $450 |
| Slide gate roller, track, and carriage repair | $225 – $550 |
| Electric gate opener repair (board, motor, limit switch) | $275 – $700 |
| Gate operator wiring and safety sensor repair | $250 – $600 |
| Keypad, remote, and access control repair | $175 – $500 |
| Full electric gate opener replacement | $650 – $1,600 |
| New gate installation (structure plus operator) | Quoted per project |
What pushes a job toward the top of a range? Parts availability for an older or less common brand, a gate that has settled out of plumb, and any repair that turns into an access-control job rather than a mechanical one. A property manager with a DoorKing unit that controls entry for a whole building is looking at a different scope than a homeowner with a single swing gate and a Mighty Mule operator. We price both, but the diagnosis takes more time on the access-control side, and that shows up in the labor.
What keeps a job at the low end? A clean, obvious failure. A gate that stopped because a hinge pin seized or a roller flattened is a same-day fix more often than not, and the parts cost less than the diagnostic time on a board-level failure. Call (888) 356-9186 for a free estimate and we’ll tell you which side of the table your gate is likely to fall on before we arrive.
What Affects Gate Repair Pricing in Alexandria
- Brand and parts availability. We’re familiar with nine major brands – LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule – so most Alexandria gates don’t need a special order. An older operator with a discontinued control board does, and that shifts the number. Because we’re brand-agnostic, we diagnose the failure and repair it; we don’t turn a board failure into a brand-switch sales pitch.
- Mechanical versus electrical. A gate that sags, drags, or won’t latch is a structural repair. A gate that won’t move when the operator runs is an automation problem. The two have different labor profiles, and a gate that has both problems at once – common in Alexandria after a wet spring loosens a post footing – costs more than either alone.
- Gate weight and material. A lightweight ornamental aluminum gate and a solid wood driveway gate both swing, but the hinge load, the operator duty rating, and the repair time aren’t close. Heavier gates wear their hardware faster, which is why we check hinges and posts on every electric repair call.
- Property type and access. A residential driveway gate in Del Ray is a straightforward site. A multi-unit entry gate in Old Town or a commercial access-controlled entrance has more moving parts – literally, in the case of vehicle loop and safety sensor wiring – and the repair has to account for traffic flow. Property and HOA managers should mention the system type when they call so we can schedule accordingly.
- Power and wiring condition. Gate operators live outdoors in Virginia’s freeze-thaw cycle and summer storms. Water intrusion into a control box, a corroded terminal, or a line that was run too shallow are all things we find on Alexandria gates, and repairing the wiring correctly takes longer than swapping a part.
- Age and service history of the operator. A well-maintained operator that fails once is usually repairable. A unit that’s been limping along on adjusted limits and a strained motor may cost more to keep than to replace, and we’ll say so plainly rather than billing you twice.
How to Save on Gate Repair
The single biggest cost saver is getting the diagnosis right the first time. A gate that “won’t open” can be a dead battery in a remote, a tripped safety sensor, a misadjusted limit switch, or a burned-out motor, and each of those is a different price. Describing the symptom precisely when you call – does the operator run at all, does the gate move an inch and stop, does it reverse halfway – helps us bring the right parts and cuts the diagnostic time.
- Don’t let a small mechanical problem become an opener problem. A gate that drags puts strain on the operator every cycle. Fix the hinge or roller before it burns out the motor, and you avoid a much larger bill.
- Clear the gate path before we arrive. Leaves, gravel, and winter debris on a slide gate track cause false obstructions that look like sensor failures. A quick clean costs nothing and sometimes solves the call entirely.
- Ask for the written estimate before work starts. Every job we do is priced per job by a written estimate, so you know the number before anyone touches a bolt.
- Repair versus replace is a real decision. We’ll tell you when a repair makes sense and when it doesn’t. We don’t have a reason to push a replacement on a gate that just needs a part, and we don’t have a reason to keep a failing operator alive either.
Read our full rundown of what gate repair covers from the motor to the hinge if you want to understand what’s involved before you call. When you’re ready, call (888) 356-9186 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Mechanical Gate Repair vs. Electric Gate Repair Pricing
Alexandria homeowners often aren’t sure whether their gate has a mechanical problem or an electrical one, and the price differs enough that it’s worth explaining. Mechanical repair covers the physical gate: hinges, latches, rollers, posts, and the frame itself. Electric or automated repair covers the operator, the control board, the safety sensors, the access control, and the wiring that connects them. Because we handle both under one roof, you don’t get sent to a second company when the diagnosis crosses from one to the other – a common and expensive runaround.
A typical mechanical repair call in Alexandria lands between $175 and $450. A typical electric gate repair lands between $275 and $700. When a failed operator has also begun to stress the gate’s hinges or a sagging gate is straining the operator, expect a combined scope and a number near the top of both ranges. We diagnose first, then quote, then work only what the written estimate covers.
Repair or Replace? How We Help You Decide
Is it cheaper to repair or replace a gate in Alexandria? Repair is cheaper in most cases – a $300 repair beats a $1,600 replacement – but replacement wins when the operator is at the end of its service life, the parts are discontinued, or the repair would cost more than half of a new unit. We’ll tell you which side of that line you’re on without pushing a sale.
The calculation looks different for the gate structure than for the operator. A sound gate with a failing opener should almost always keep the gate and replace the opener, especially if the gate was installed correctly and fits the opening. An operator that’s fine but a gate that’s racked, rusted at the weld points, or came off its track may be worth replacing as a complete assembly. For property and HOA managers, the replacement math also has to account for downtime on an access-controlled entrance, so we make sure the estimate includes the realistic schedule.
Whichever way you go, the brand you already own is the starting point. We service the automation brands most Alexandria gates run on, which means less downtime and no forced brand switch. Call (888) 356-9186 and we’ll talk through your specific gate, operator, and budget.
Why Alexandria Gate Prices Differ From Other Cities
Gate repair costs in Alexandria reflect the local mix of property types and the region’s weather. The area has a large stock of older homes with narrow driveways and swing gates, alongside mid-century and newer properties with wider driveway openings and slide gates. Older driveways often mean gates that were retrofitted years after the house was built, with power run through less-than-ideal routes. That history shows up in the labor on repair calls.
Northern Virginia’s freeze-thaw cycle also does specific work on gate posts and footings. A post set to proper footing depth handles the cycle well; a post that was set shallow can shift by a fraction of an inch each winter, and after a few seasons the gate swings out of alignment and the operator starts fighting it. When we find that on an Alexandria repair, we’ll show you the post and recommend the fix rather than simply readjusting the operator and letting it fail again next winter.
When you compare a quote from a gate specialist to one from a general handyman or a garage door company, compare the diagnosis too. Brand familiarity with the operator means faster repair, and gate-only focus means the person looking at your gate does it every day. We work on residential driveways and commercial or multi-unit entry systems, and we cover full project scope from emergency repair to new installation.
What Happens When You Call
We answer 24/7. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm. We’re closed on Saturday, and a gate that fails on a Saturday can be booked for Sunday.
The call starts with a few questions: what type of gate, manual or automated, which operator brand if you know it, and what the gate is doing (or not doing). With that, we can often narrow the cause before we arrive. On-site, our technician diagnoses the failure with the gate in front of them, checks the mechanical structure and the automation together, and writes the estimate. You get the price in writing. We do the approved work. And you get a gate that works, whether that turned out to be a $200 adjustment or a $1,200 replacement.
FAQs – Gate Repair Cost
How much does gate repair cost in Alexandria, VA?
Gate repair in Alexandria typically costs $175 to $650, depending on whether the problem is mechanical or in the automation. Simple hinge, latch, or roller repairs sit at the low end, while electric gate opener and access-control repairs run higher. Call (888) 356-9186 for an exact quote – estimates are free.
How much does electric gate opener repair cost?
Electric gate opener repair usually runs $275 to $700 in Alexandria, depending on whether the failure is a control board, a limit switch, a motor, or wiring. Parts availability for your specific brand matters. We service the brand you already have. Call (888) 356-9186 for a free estimate.
Is it cheaper to repair or replace a gate?
Repair is usually cheaper – a $300 repair typically beats a $1,600 replacement – but replacement makes sense when the operator is at the end of its service life or the parts are discontinued. We’ll tell you which one applies and won’t push a sale. Call (888) 356-9186 for a free estimate.
Can you come today?
Same-day service is often available in Alexandria, depending on the schedule and the diagnosis. Fast dispatch runs from 7am to 7pm, Sunday through Friday, and we’re closed on Saturday. Call (888) 356-9186 to check availability and get a free estimate.
Do you charge for estimates?
No. Estimates are free, and every job is priced per job by the written estimate, so you know the final number before any work starts. Our technicians have up to 12 years of experience and we work on nine major gate automation brands. Call (888) 356-9186 to book yours.
What gate brands do you repair in Alexandria?
We work on nine major gate automation brands: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. That covers most of the systems on Alexandria driveways and commercial entrances. Call (888) 356-9186 if you’re not sure which brand you have – we’ll help you identify it.
Pricing reflects the Alexandria market as of 2026. Alexandria Gate Repair offers free estimates – call (888) 356-9186.
Written by the team at Alexandria Gate Repair.
What Our Customers Say
"Our slide gate had been dragging for months and getting worse. Turned out the chain was stretched and one of the guide rollers had seized. Both replaced, and he adjusted the limits so it stops properly at both ends now."
- Sanjay Singh"The loop detector under the driveway had failed and residents were stuck holding the button. He traced it, found the break, and had the exit loop reading cars again the same visit."
- Jasmine Carter"Hinge post had rotted at the base and the whole swing gate was sagging into the concrete. He rebuilt the post rather than talking us into a whole new gate, which two other companies had pushed for."
- Eric Sullivan